diff --git a/content/rambles/pwr-switch.md b/content/rambles/pwr-switch.md
index c6ef0fc..c8642df 100644
--- a/content/rambles/pwr-switch.md
+++ b/content/rambles/pwr-switch.md
@@ -21,7 +21,7 @@ The solution was an [Olimex PWR-switch](https://www.olimex.com/Products/Duino/Sh
 
 Setting it up was relatively easy.
 
-First I connected my lamp to a European extension cord socket to a random power cable I still had laying around.
+First I connected a European extension socket to a random 230 volt cable I still had laying around.
 Then I hooked that up to my PWR-switch and plugged my lamp into that contraption.
 
 From there I got little bag of jumper wires from my local electronics store and hooked up the PWR-switch to my Raspberry Pi.
@@ -30,7 +30,7 @@ I hooked up the PWR-switch's positive to `GPIO 15` and it's ground to the preced
 
 _Note_, `GPIO 15` is in reference to pin number 10 and the preceding ground pin is pin number 6.
 
-From there I looked up how to send power to `GPIO 15` in order to have it switch to on.
+From there I looked up how to send power to `GPIO 15` in order to have it toggle to the "on" state.
 The first step to this end is to initialise the pin.
 This can be done with:
 ```sh